Roll On Rock® Vinyl Chip Epoxy Concrete Coating
|
|
The Roll On Rock® System 2 (NOW ALSO AVAILABLE AS A 3-6 HOUR 1 DAY INSTALL) is a very easy to install Epoxy full broadcast flake coating system. System 2 is designed to be a 2 step application which uses 4195 as the primer and chip receiver coat. The 4195 incorporates our proprietary wicking technology which allows it to wick deep into concrete surfaces. This unique technology provides 3 times the adhesion of a standard epoxy installed over a profiled floor. That is why 4195 epoxy will withstand over 8 lbs of MVE where others fail at 3 lbs. A typical installation would be to apply the 4195 over porous concrete and throw the flakes to rejection (about 55lbs of flake for a 2 car garage) within 45 minutes of applying the 4195. Then come back the next day to scrape the loose flakes off (if you save then you can use them on the next job) and then apply the clear topcoat. One coat is what most installers apply but about 30% of them install 2 coats to get a higher build. VBP offers 4 different Topcoats to choose from, 3 of them are below 10 VOC and 2 of them are Low Odor and Non-Flammable. All of these topcoats will not yellow, are hot tire resistant and extremely abrasion resistant. These ultra low VOC topcoats help provide a solution for areas that are environmentally conscious (reduce the effect on Global Warming) as well as areas that can not allow a solvent based system . All of these systems are also compliant with the new strict SCAQMD rules that become law July 2006. See the chart below for the pros and cons for each system. This range of floor coatings designed specifically for the garage floor is just one more reason why VBP is the leader in the garage floor and industrial coating industry.
Click here to see how our Polyurea beat the Flexmar Polyaspartic in an independent test
HOT TIP.....
See the new 1 day install guide below and see how you can get better adhesion and only need 2 steps to do it in.
Use PolyUrea 5000 as the one coat Topcoat that gives the look and feel of 2 coats of CRU. 5000 is shinier and just as hot tire resistant as the CRU but will save you a trip to the jobsite, plus it is Non-Flammable and does not stink!
Or try the very popular Polyurea 5073, its claim to fame is the extra long potlife, great viscosity and the best part is you can walk on it in a little over 2 hours!
GARAGE FLOOR COATING EXTREME HOT WEATHER TIP....
Use the waterbased 5400 waterbased CRU topcoat, but be sure to keep material cool. You will not get solvent blisters associated with solventborne CRU's.
Click Here To See a Video on How to Install Our High Build Polyurea 5000 Topcoat
|
Features & Advantages |
|
 Low Odor Materials
Hot Tire Resistant
Looks Like Granite
Easy to clean
Installs in 2 days
Industrial Grade Material
Can Withstand up to 8 LBS M.V.E. Without Peeling
|
|
Pros and Cons, Which System is Right for Me?
The 4 Standard Roll On Rock™ Systems Offered by Versatile Building Products, Inc.
All 3 systems perform well and offer the same appearance when completed. The main difference is the amount of MVE transmission (moisture vapor emissions)that they can withstand before blowing off the surface and the ease of application and coats required. Use the data below to make a decision on what works best for your project. Then review the installation guides to be familiar with how they are applied.
| Epoxy Basecoat Data |
System 1 |
System 2 |
System 3 |
System 4
(Professional Use Only) |
| Epoxy Basecoat Used |
4010-4020 Waterbased Series |
4195 95% Solids Series |
4150 100% Solids Series |
Hybrid 5210 Scrape in 1 Hour |
| Easy to apply |
Easy |
Easy |
Moderate |
Yes |
| Primer Needed |
Yes, Coatable in 1 hour |
No, Self Priming |
No, Self Priming |
Yes, Hybrid 5205 dry in 30 min |
| Odor |
Very Mild |
Very Mild |
Very Mild |
Moderate |
| Flammable |
No |
No |
No |
Yes |
| Clean Up With |
Water |
Solvent |
Solvent |
Solvent |
| Basecoat Pot Life |
1 Hour |
3 hours |
1 hour |
Over 60 Minutes for both |
| Chipping Window |
15-30 Minutes after Applying |
15-45 Minutes after Applying |
44-60 Minutes after Applying |
Over 20 Minutes after applying |
| Acceptable MVE |
8 LBS |
10 LBS |
12 LBS |
6 LBS |
| VOC |
6 VOC (primer) & 49 VOC |
29 VOC |
28 VOC |
Under 10 |
| Pot Life In Extreme Heat |
Great |
Moderate |
Moderate |
Over 60 Minutes |
| Viscosity |
Great |
Great |
Good |
Great |
| Helps Reduce Global Warming |
Yes, Below 50 VOC |
Yes, Below 30 VOC |
Yes, Below 30 VOC |
Yes, Below 10 VOC |
| |
| Clear Topcoat Choices |
Solventborne 5300 Series |
Waterbased CRU 5400 |
Polyurea 5000 |
Polyurea 5073 |
| VOC |
100-400 |
45/Gloss 16/Matte |
9 |
9 |
| Odor |
Bad Solvent Smell |
Pleasant |
Pleasant |
Mild Odor, causes light headedness |
| Flammable |
Yes |
No |
No |
Yes |
| Gloss |
Good |
Good |
Great |
Great |
| Matte Finish |
No |
Yes |
No |
No |
| % Solids Content |
53 |
61/ Gloss 63/ Matte |
100 |
High |
| Exterior Use |
Yes |
Yes |
Yes |
Yes |
| Will It Yellow |
No |
No |
No |
No |
| Hot Tire Resistant |
Yes |
Yes |
Yes |
Yes |
| Resistance to Household Chemicals |
Great |
Great |
Great |
Great |
| Clean Up With |
Solvent |
Water |
Solvent |
Solvent |
| Easy To Apply |
Moderate |
Yes, Very |
Moderate to Difficult |
Yes |
| Pot Life In Extreme Heat |
Moderate |
Great |
Moderate |
Good |
| Viscosity |
Good |
Great |
Good |
Great |
| Dry Film Build When Applied at 250 per gal |
3 Mils |
3.5 Mils |
6 Mils |
4.5 |
| Helps Reduce Global Warming |
No, Very High VOC |
Yes, below 50 VOC |
Yes, below 10 VOC |
Yes, below 10 VOC |
|
Literature |
|
Install Guides |
|
5073 Installation Tips Guide |
|
MSDS (see individual components as needed per install guide) |
|
Installation Videos |
|
|
Go out on a job with a contractor who does 10-15 garage floors a week. You will see each step of the process done over several different jobs in 1 day. |
 |
|
Roll On Rock® is the #1 choice for professionals that make it a full time business installing garage floor coatings.
Roll On Rock® Will Not Peel from Hot Tires!
|
